How To Build Your Own Robot Rover

Spread the love

Building a robot, is not going to be an easy thing to do. This is especially the case if you are not familiar with using electronic hardware equipment or software programming. However, you might have to be familiar with the use of sensors and other electronic equipment, or have a sound knowledge in electrical engineering. Here is a basic outline of some of the key requirements you will need to build your robot.  


This is pretty much going to be the brain of the robot. Without using a micro-controller, the robot will not be able to operate. Any sensor or other device, will have to be connected to the microcontroller for it to operate. Therefore, if you are going to be looking for a RF product manufacturer in China, to use with the robot, you will need to check its compatibility with your microcontroller. One of the most popular and most versatile commercially available microcontroller company is Arduino. They have a wide range of microcontrollers that you can choose from, based on your requirement. 

Programming logic 

Once you have your microcontroller, you will have to program it according to your requirements. When programming the microcontroller, you will need to use the language that the chip is compatible with. For the case of Arduino, it will be Arduino IDE, which is an open source programming language, based on C programming. Getting familiar with the program syntax will be your first step. Once you have acquired reasonable knowledge on programming, then you will need to test your program by uploading it to the microcontroller. Most microcontrollers will allow you to reprogram them, so you can always make tweaks or correct any bugs that you encounter.  

Get the chassis 

Although you can construct the chassis of the robot or rover yourself, it is going to be a lot easier to purchase a premade body. This will be available at most electronic stores or even your Bluetooth device manufacturer, if you are going to be using one. If you are going to be controlling the robot in real time, then you will need to make sure it has sufficient space to place a receiver on it. This will not be very hard to implement, as there are several breakout boards that allow you to do this. Once you get the chassis you will have to provide a power source and wire it up with your microcontroller to get it mobile.   

These are three essential steps that you will require to build your own robot. Remember, that it might not be as easy or straightforward if you do not have some knowledge in electronics and IT. You can view more information about these products by visiting

Leave a Comment

Your email address will not be published. Required fields are marked *